Цитата сообщения Nadin72
МК мужской рубахи для куклы
МК мужской рубахи для куклы
Shirt for Iplehouse EID Guys
This pattern is for a simple, traditional, one-size-fits-all "pirate-style" shirt, made of basic rectangles with off-the shoulder, gathered sleeves and a gathered neckline. It would traditionally have not been open all the way down the front, but I made it that way to make it easier to put on and take off.
Shirt Patterns
Click on pattern image below to download pdf with full-size patterns
Materials
- 2/3 yard cotton crinkle gauze or other soft woven fabric
- matching coloured thread for sewing, and contrasting thread for embroidery
- scissors, pins, needles
- snap fasteners
Instructions
1. Download pdf and print out patterns. The patterns are too big for a single sheet of paper, so they've been drawn in parts and need to be re-attached. Cut out the patterns, then using strips of scrap paper glue shirt front and back pieces together at shoulder. Also glue two parts of sleeve pattern together butting paper edges (do not overlap)
2. Pin patterns onto fabric paying attention to straight of grain and folds. Cut out.
3. Sew a rolled hem along both side edges of sleeves. *to make a rolled hem fold the raw edge in 1/4", then fold that over again so raw edge is folded inside. Then stitch.
4. Gather sleeves onto cuffs. *tip for more even gathering - divide width of sleeve end and cuff fabric into quarters, marking with pins, then match up the pins.
5. Finish sleeve cuffs, by folding seam allowances in, folding cuff fabric back, and pinning in place as shown. Hand-stitch neatly with small stitches.
6. Make shirt ties. You can either fold the ties right-sides together, sew along the edge by machine and turn it right-side-out, or, if like me you find it too difficult to turn something so narrow, fold the seam edges in, then fold the ties lengthwise in half and hand-sew. Tie knot in tie at one end.
7. Sew rolled seams along center front edges of shirt.
Gather shirt neckline onto collar using same technique as gathering sleeves in step 4. Fold collar in half lengthwise, right sides together, and insert non-knotted end of tie, then sew end of collar.
Turn right side out, fold inside collar edge under and pin into place. Hand-sew with tiny stitches.
8. Sew sleeves onto shirt easing to fit ( just a few small gathers needed) Zig-zag raw edges.
9. Optional embroidered edges. If your sewing machine has fancy stitches, top-stitch sleeve seams on right side, collar and cuffs with a contrasting coloured thread.
10. Fold shirt at shoulders with right side inside, and sew side and underarm seams, leaving 2" at sleeve end open. Clip armpit, and zig-zag raw edges along side.
11. Make rolled hem at bottom of shirt - sew by hand. Sew snap fasteners on cuffs and along front. You can also add buttons, but I chose not to.
Finished Shirt
*Note - when the sample shirt was finished it was way too wide, and I discovered I'd accidentally made the pattern too wide at the shoulder. So, instead of starting over from scratch, I just sewed a tuck on both sides to make the shirt the right width. You won't need to do this, as I have reworked the patterns so they are the correct width. Your shirt will look like this, but without the two tucks sewn up the main shirt body.
Источник
