Коробочка. МК

Четверг, 17 Мая 2018 г. 17:43 + в цитатник

Цитата сообщения Мадам_Ирина

Прочитать целиком В свой цитатник или сообщество!

Коробочка.МК

Коробочка.МК

Как сшить сцепление - книжный пакет. Учебник и шаблон

Как сделать клатч - книга - стильный аксессуар , который когда - то выиграл мое сердце с первого взгляда.

The materials that will be needed for:1. Binding cardboard 2 mm.2. Thick paper or paperboard density of 200-300 g / m2.3. Fabrics two or three colors, one of which has to be soft beige or cream color. The fabric for the cover of needs in the amount of 25 cm by 50 cm, the
fabric for finishing the interior of the clutch - 25 cm by 100-110 cm
for the "pages" Cloth (single-colored beige) - 10 cm by 75 cm.4. Felt Sheet slightly larger than A4, and the sheet-sublimation print with cover.5. Seals of one or more species (for patchwork, fleece, padding polyester, etc.).6. Accessories - any lock s magnetic button, corners for scrapbook papers.

The first step is to cut the cardboard. the size and number of such scheme.

Preparing details number 1, № 6-9, glue and masking tape.

We begin to glue the box. First, the short sides

Then the long sides

We try all neatly docked, it is important to accurate to the millimeter, match the size of all the details.

Additionally glue masking tape all joints outside the box and inside.

Then prepare a strip of fleece or other sealant 5 cm by 70 cm.

And paste a strip on the side of the box.

Now it is the turn of a beige cotton. We take our band and her skin-tight box.

The strip of fabric should be fairly wide, enough to both the bottom of the box, and on the inner side of it.

Sealed edges, as shown in the photo. The joint hem make out through one of the short ends of the fabric strip.

Now we go to a thin cardboard, take details number 10-14.

Each of the details skin-tight fabric.

Part of the binding cardboard number 2 too tight fitting at this stage, but a little differently, leaving a large allowance on one of the long sides.

In this detail, which should become the cover of our boxes, we sew the pocket and label. For pocket trapezoid need of fabric with the upper base of 12 cm and 8 cm lower, folded in half over a larger base. Paving the stitches along the sides of the parts and the lower side, leaving a hole for eversion. To turn out to do, and stripped. Then take the rubber band paste it into the details to the larger side, and hand stitched edge of the rubber band to the corners of the trapezoid.

Then we lay on top of the seam, the greater side of the part, uniformly pulling an elastic band during sewing.

Ready pocket impose on the cover boxes and sew, trying to do everything exactly. At this stage, if you want, we sew label.